Your Source for Documentation

One of our main business fields are scanners, galvos and drivers. With more than 6,000 sold OEM scansets, MediaLas is one of the largest and most experienced supplier worldwide. If you search for reliable OEM galvo system, this is the right place!



Trade Shows

CTi Galvo Set

MicroAmp Manual


Overview


The new designed position detector allows to increase in-picture details, and offers more stability during high speed scanning. CT-SET IV comes with the latest MicroAmp II drivers for increased performance and speed! Driver includes various galvo protection circuits.

Comes with:

 

2x MicroAmp driver
2x CT6210 galvanometers with mirror
2x galvo mount, adjustable
2x High Shield connecting cable between driver and galvo


Up to 60,000 pps scan speed, depending on projection angle. Fully adjusted for 45k ILDA standard and tested, ready to go!


Trade Shows

TeraScan II Galvo System

Data Sheet
Blanking with CT galvos




Overview


Smallest galvanometer scanner from Cambridge Tech. Developed on the famous 6800, the new 6210 allows higher speed at low angles. Super compact dimensions of the galvo, small projector designs possible. Runs with MicroAmp. Large optical angle of 80° max. High End system for very precise scanning and pointing.

Technical data


 

Max. speed:
Max deflection:
Recomm. deflection:
Mirror aperture:

60.000 pps @ 7° opt.
80° optical
60° optical
3,5mm, optional 4.5mm available



Trade Shows

TeraScan II Galvo System

Manual Rev 2008




Overview


The new development is here! Very fast and low cost scan set with new developed galvos and a true scan speed of up to 45,000pps, measured at ILDA standard measuring method! Very good projection quality for full graphical details. Small dual channel driver with full groundless differential inputs. Various protection circuits for galvo safety.

Set comes with standard 5x11mm mirrors, larger 6x11mm mirrors are available on request.


Comes with:


     2x galvos
     2x mounts
     Dual channel driver
     2x High Shield connecting cable
     2x mirror 5x11mm
     Required power supply: TeraPSU.
 
TeraScan II comes pre adjusted to 35k ILDA Standard.

Technical data


 

Deflection angle:
Scan speed:
Input:
Power:
Mirror aperture:

max. 70° optical
up to 45,000pps with 5x10mm mirror
Analog +/-5V
+/- 24VDC to +/-30VDC @ 1.2A
3.5mm, optional 4.5mm



Trade Shows

CTi Power Supply Unit II
Brochure
Adjustment procedure and information






Overview


Super-compact high speed driver for Cambridge Tech´s CT6800HP or 6210H in new 2008 revision! Latest circuit technology with:

 

  • oscillation prevention circuit

  • over temperature protection

  • coil temperature calculator

  • differential input and increased speed

 

Very small dimensions, just 63x50mm. Adjustment for Picture Size, Servo Gain, Damping and Offset. Inverting jumper. Needs source of +/- 24-30VDC at 1A per voltage. Scan speed as high as 60kpps with CTi 6210H galvos. Latest revision offers increased picture quality and higher speed at large scanning angles.

 

Driver comes pretuned to desired galvo, fine tuning might be necessary.

MicroAmp II 68 - For CTi 6800HP
MicroAmp II 62 - For CTi 6210H


Trade Shows

CTi Power Supply Unit


Overview


Switching power supply boards for multi voltage input 90 - 250VAC. . Output 30V @ 2A each. Compact and reliable design, low noise. Fits to CAT-AMP or 2x MicroAmp. Gets full performance out of each amp. Dimensions 100x60x40mm per board.







www.medialas.cominfo@medialas.com
MediaLas Electronics GmbH • Hoelzlestr. 13 • 72336 Balingen / Germany • Phone +49 7433 90799-0 • Fax +49 7433 90799-22